Sterling 950C-32S Guia de Instalação descarregar pdf (Página 11)

12. Measure and Cut the Drip Rail

Measure from the edge of the strike jamb to the edge of the hinge jamb.

Subtract 1/8″ (3 mm) from the measured distance and cut the drip rail to that measurement.

File the rough edges until they are smooth.

13. Install the Flat Seal

IMPORTANT! If the seal is misshapen when taken out of the packaging, immerse it in warm water until

it regains its proper shape.

NOTE: Water or petroleum jelly may help when sliding the seal in place.

Slide the seal into the groove in the drip rail.

Cut the seal to the same length as the drip rail.

Crimp each end of the drip rail with pliers to hold the seal in place.

Top View

Swing open

toward right

Subtract 1/8" (3 mm)

From Measurement

Subtract 1/8" (3 mm)

From Measurement

Hinge

Jamb

Hinge

Jamb

Strike

Jamb

Strike

Jamb

Swing open

toward left

Crimp each

end of drip rail.

Double

Face Tape

Seal

Drip Rail

Seal

Installed

Drip Rail

Sterling 11 1034023-2-D

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 39 40

Sem comentários

Sterling 950C-32S Guia de Instalação Página 11